Assembly procedure for shower frame and base
Step 1 Round shower model SIZE:80x80x209cm |
Step 2 Shower tray assembly. Level the shower tray feet below the base and connect to your waste pipe. |
Step 3 Attach accessories to rear panel and connect water supply hoses to your water mains, Test for any leaks on the hoses behind |
Step 4 Attach any accessories if the wall has them included Lock the side rear wall to the middle panel and rotate until it locks into position Bottom of rear wall aluminium will slide under the aluminium on the base to lock into position |
Step 5 Attach any accessories if the wall has them included Lock the 2nd rear wall to the middle panel and rotate until it locks into position Bottom of rear wall aluminium will slide under the aluminium on the base to lock into position |
Step 6 Place one of the curved rails at the front of the shower tray with the flat side down. |
Step 7 Lock the front fixed glass to the rear side wall and rotate until it locks into position Slide the fixed glass panel down the rear side so the cut out on the front glass aluminium slides over the block on the curved rail. Place the glass panel behind the block on the curved rail to lock into position |
Step 8 Slide the top curved rail so the block slides into the slot of the front fixed glass aluminium Lock the glass panels behind the blocks on the curved rail |
Step 9 Slide the locking blocks on each corner of the curved rail to lock the curved rails to the frame |
Step 10
|
Step 11
|
Step 12 Attach water splash strips to front fixed glass and inside section of door. Trim any excess splash strip
The shower comes with optional wall mounts. To use them attach one edge to the side of the walls that are against you bathroom wall and the other edge to the bathroom wall. |
If you have any questions or require assistance leave a comment below or use our customer service form from this link